Process safety management review
Process safety controls for facilities handling hazardous materials — barriers, integrity and change control.
ISO 45001OSHAISO 14001
19 questions~75 minannual
Typically run by Process Safety Engineer
Loading AuditFlow…
Energy
Power generation, renewables, oil & gas, water utilities and mining operations.
The job you're hiring this for
Demonstrating process safety and permit-to-work discipline to regulators, where a single control failure has catastrophic consequences.
Every one carries weighted questions, auditor guidance and clause references — ready to run, or to edit into your own house standard.
Process safety controls for facilities handling hazardous materials — barriers, integrity and change control.
Typically run by Process Safety Engineer
Energy management system audit covering the energy review, EnPIs, baselines and operational control of significant energy uses.
Typically run by Energy Manager
Routine inspection of an indoor or outdoor substation covering switchgear, earthing, protection, access and housekeeping.
Typically run by Electrical Maintenance Engineer
Audits an HV switching and permit event end to end: authorisation, isolation, earthing, testing, limits and cancellation.
Typically run by Authorised Person (HV) / HSE Lead
Field inspection of a PV plant covering module condition, DC string integrity, inverter health, earthing and access safety.
Typically run by Solar O&M Engineer
Safety controls for work in and on a wind turbine: access, rescue, isolation, lifting and lightning protection.
Typically run by Wind O&M HSE Lead
Condition assessment of a power transformer: oil, bushings, cooling, protection devices, earthing and containment.
Typically run by Electrical Maintenance Engineer
Combustion efficiency, steam distribution losses, water chemistry and statutory boiler compliance in a single pass.
Typically run by Energy Manager / Boiler Engineer
Load test and readiness check of standby generation and UPS, covering changeover, fuel, emissions and containment.
Typically run by Facilities / Electrical Engineer
Verifies arc flash study currency, equipment labelling, boundary control and the condition and rating of electrical PPE.
Typically run by Electrical Safety Lead
Physical and logical access control over the control room and SCADA environment, including remote access and change control.
Typically run by OT Security / Control Systems Engineer
Verifies stack and effluent monitoring against consent conditions, including instrument integrity, treatment operation and reporting.
Typically run by Environment Officer
Each of these has a real control library in the product — questions map to specific clauses, so gap analysis shows you what is genuinely unevidenced.
Occupational health and safety management — replaces OHSAS 18001.
20 controls mapped
Environmental management system covering aspects, impacts and compliance obligations.
20 controls mapped
Energy management system for systematically improving energy performance.
12 controls mapped
The world's most widely adopted quality management system standard.
21 controls mapped
Business continuity management — impact analysis, strategies and tested plans.
12 controls mapped
US federal workplace safety standards — the most-cited general industry requirements.
16 controls mapped
Not hypotheticals. These are the findings that recur in energy & utilities, and every one of them is a question in at least one of the 12 templates above.
Templates, findings and AI prompts use your sector's terms, not generic audit language.
Pick one of the 12 templates above, walk the site with your phone, and see the finished report before you get back to your desk.